Current location:Home News Information 公司新闻
CE1434 Approved!-CITEST SARS-CoV-2 S-RBD IgG Antibody Rapid Test
Release Time:2022-06-11
Share

CE1434 Approved!-CITEST SARS-CoV-2 S-RBD IgG Antibody Rapid Test  

 

The SARS-CoV-2 S-RBD IgG Antibody Rapid Test (Fingerstick Whole Blood) is a rapid chromatographic immunoassay intended for the qualitative detection of IgG antibodies to SARS-CoV-2 spike (S) protein receptor binding domain (RBD) in human Fingerstick Whole Blood approximately 10 days after vaccination.

 

It is intended for use as an aid in identifying individuals with an adaptive immune response to SARS-CoV-2. Results are for the detection of SARS-CoV-2 S-RBD IgG antibodies. Positive results indicate the presence of IgG antibodies to SARS-CoV-2.

 

Before testing:

Allow the test and buffer to room temperature (15-30°C) before testing.

 

Wash hands thoroughly in warm water and dry.

Take out the test cassette from the foil pouch and use it within 1 hour. Do not touch the test reaction area (strip area beside to C, T, S) of the test strip. Best results will be obtained if the assay is performed immediately after opening.

 

Place the test on a flat and clean surface.

1. Use alcohol pad to clean the fingertip of the middle finger or ring finger as the puncture site. Let it dry for 10 seconds.

2. Carefully rotate and pull off the lancet cap. Only open the lancet before testing.

3. Press the sterile lancet firmly against the fingertip of the middle finger or ring finger.

4. To increase blood flow, use the thumb and forefinger to gently apply pressure around the puncture site.

5. Without squeezing the dropper, put it in contact with the blood. Draw the blood to the line indicated on the dropper. You may massage again your finger to obtain more blood if the line is not reached. Avoid air bubbles, discard the blood into a plastic bag (e.g., biosafety bag) if air bubbles happen, then repeat above collecting steps.

6. Put the end of the dropper in contact with the center of the specimen well(S) and release all the blood immediately after collection.

7. Add 2 drops of buffer to the Specimen well(S) and start the timer. Do not move the test during test developing.

8. Read results at 10 minutes. Do not interpret the result after 20 minutes.

 

 CITEST COVID-19 Ag&Ab OTC  4 tests(1).jpg

 


Top Results!- From Germany PEI Evaluation Top Results!- From Germany PEI Evaluation